Worried knitting looks too fiddly to try? The basic knitting stitches come down to five moves: slip knot, cast on, knit, purl and bind off. Learn those and you can make a simple scarf.
If you are brand new to the craft, start with our guide to knitting and crochet for beginners before you pick up the needles.
| Item | Value |
|---|---|
| Beginner yarn and needles | DK weight yarn with 4mm needles, or aran weight with 5mm needles |
| Yarn to measure for a simple cast on | About 1 inch per stitch |
| Tail left at the free end for the slip knot | About 4 inches |
| The slip knot | Counts as your first stitch |
| Bind off, first move | Knit the first 2 stitches |
| Purl stitch | The reverse of the knit stitch |
The figures come from the Craft Yarn Council’s knitting diagrams and the Gathered beginner knitting guide. They can change, so check those pages before you rely on them.
What you need before the first stitch
Knitting is a way of making fabric by interlocking loops of yarn with needles, as Lion Brand’s how-to-knit page describes it. You can start with very little kit.
- Yarn: Lion Brand suggests beginners may find medium weight yarn in a light color easiest, because the stitches are easier to see.
- Needles for learning: Gathered recommends smooth wool or acrylic yarn, either DK weight with 4mm needles or aran weight with 5mm needles.
- Needle material: Lion Brand notes that needles come in materials such as metal, bamboo or plastic.
- Needle type: straight needles are typically used for flat knitting such as scarves and blankets, while circular needles work for both flat and circular knitting.
Knitting differs from crochet, which uses a single hook and makes knot-like stitches rather than interlocking ones, according to the same Gathered guide.
The steps below follow a right-handed knitter. The Knitting & Crochet Guild’s start-to-knit notes use the same approach, with the yarn held in the right hand.
Make a slip knot and cast on
Every piece starts with a slip knot. Make a yarn loop, leave a tail, put the needle through the loop and draw up the yarn from the free end. The Craft Yarn Council says to leave about 4 inches at the free end, and that the slip knot counts as your first stitch.
Measure your yarn before you begin. For the simple one-needle method, the same source says to measure about 1 inch of yarn for each stitch you plan to cast on.
Then work the cast on, using one needle only:
- Hold the needle with the slip knot in your right hand, with the yarn from the skein to your left. Make a yarn loop with your left hand and put the needle into it.
- Still holding the loop, pick up the yarn from the skein with your right hand and bring it back to front around the needle.
- Bring the needle through the loop toward you, pulling gently on the yarn end. Keep the new loop snug but not tight below the needle.
- Repeat for each extra stitch you need.
Another popular route is the long-tail cast on. The Knitting & Crochet Guild gives a rule of thumb of about 1 yard of tail for 75 stitches. It adds that starting with a purl row gives a smoother edge than starting with a knit row, and makes it easier to pick up stitches for an edging later.

The knit stitch, step by step
The knit stitch is the one you will repeat most as a beginner. Hold the needle with the cast-on stitches in your left hand, then follow the Craft Yarn Council’s knit stitch diagrams:
- Insert the point of the right needle into the first stitch, from right to left.
- With your right index finger, bring the yarn under and over the point of the right needle.
- With the right needle, pull the yarn back through the stitch.
- Slip the loop off the left needle, so the new stitch sits entirely on the right needle.
Gathered notes that new knitters often throw the yarn, letting go of the needle to move the yarn around it. That is fine at first, though it can lead to tight, uneven stitches, so once you feel confident try guiding the yarn with your index finger instead.
For holding the needles, Gathered describes a pen method, with the left needle held about 5cm from the point, and a knife method. Use whichever grip feels natural and try not to hold the needles too tight.
The purl stitch
The purl stitch is the reverse of the knit stitch, according to the Craft Yarn Council. Instead of entering the stitch from the back, the right needle goes in from right to left in front of the left needle.
- Take the tip of the right needle across the front of the left needle and into the first stitch, moving right to left.
- Hold the yarn in front of the work, on the side toward you, and bring it around the right needle counterclockwise.
- Draw the yarn through that stitch with the tip of the right needle, forming a new loop.
- Slide the stitch off the left needle, leaving the new stitch on the right needle.
That makes one complete purl stitch. Practise a few rows of knit, then a few of purl, until the hand movements feel steady.
How do you bind off?
When the piece is finished, you bind off to get it off the needles. On a knit row, the Craft Yarn Council says to start by knitting the first 2 stitches, as set out in its binding off instructions.
- Put the left needle into the first of those stitches and draw it up and over the second stitch and completely off the needle. One stitch is now bound off.
- Knit one more stitch, then draw the first stitch on the right needle over it and off.
- Repeat until one loop remains on the right-hand needle.
- Cut the yarn and draw the end through the last loop to tighten it.
To bind off on a purl row, the method is the same but you purl each stitch instead of knitting it.
Where to go from here
Once the five moves feel comfortable, a few small habits will help your next project.
- Make a tension square, also called a gauge swatch, to help make sure your project ends up the right size, as the Knitting & Crochet Guild suggests.
- Try other ways to cast on, since different methods suit different projects.
- Visit a knitting group if you get stuck. Gathered says many yarn shops hold sessions.
If you would like to try the other craft too, the crochet hook sizes chart covers the tools. Our page on how to read a crochet pattern covers the written instructions.
Frequently asked questions
Which basic knitting stitch should I learn first?
Show answer
Most guides begin with the slip knot and cast on, then the knit stitch. Gathered points out that some people prefer to ask someone else to cast on first, learn the knit stitch and the cast off, and return to casting on afterwards.
Is purl harder than knit?
Show answer
Purl uses the same loop-through-loop idea, just mirrored. The right needle enters the stitch from the other direction, which is why the Craft Yarn Council calls it the reverse of knit.
What if my cast-on edge is too tight?
Show answer
The Knitting & Crochet Guild suggests using a needle one or two sizes larger for the cast on if yours usually comes out tight.
Can left-handed knitters use these steps?
Show answer
Yes, with a swap. Gathered explains that its instructions are written for right-handed knitters, so a left-handed knitter reverses every left and right, and viewing the images in a mirror can help.


